EMC QLogic Guide d'installation télécharger pdf (Page 42)

EMC Host Connectivity with QLogic FC and iSCSI HBAs and FCoE CNAs for the Linux Environment

Installing and Configuring the BIOS Settings

Note: For Linux attach, EMC recommends setting the Connection Options

parameter to 1 when attached to a fabric and to 0 when attached to an EMC

storage array directly.

Fibre Channel over Ethernet (FCoE) CNAs

EMC recommends the default settings for the QLogic CNAs. There

are no settings to the BIOS or NVRAM to alter.

iSCSI HBAs

The only settings that are required to complete the installation are

those of the intended iSCSI targets. The iSCSI targets must reside on

the same subnet as the initiator.

The iSCSI targets must be configured after the QLogic v3.x-series or

5.x-series driver has been installed and is operating. Additionally, to

establish these settings, the SANsurfer GUI or the SANsurferCLI

must be downloaded and installed on the host.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 215 216

Pas de commentaire

EMC QLogic Guide d'installation Page 42