EMC QLogic Guide d'installation télécharger pdf (Page 110)

110

EMC Host Connectivity with QLogic FC and iSCSI HBAs and FCoE CNAs for the Linux Environment

Installing and Configuring the Linux Host with the QLogic Driver

In the /etc/modprobe.conf file, the hostadapter line for the

qla4xxx driver will be appended.

Note: The Unisphere/Navisphere Host Agent requires that the disconnected

LUN 0 be reported.

The DKMS RPM will create the QLogic v5.x-series driver as a

module.

Follow these steps to integrate the QLogic driver into RHEL 4.0 hosts:

1. Boot into the qualified and supported kernel onto which the

driver will be installed.

2. Obtain the

qliscsi-linux-5.00.4-1dkms.tar.gz package from

EMC-approved section of the QLogic website as instructed in

“Downloading the QLogic v3.x-Series iSCSI driver for the v2.4.x

kernel” on page 98.

3. Uncompress and extract the source files from the tar archive:

tar zxvf qliscsi-linux-5.00.04-1dkms.tar.gz

The initial decompression will provide you with the following:

qla4xxx-5.00.04-1dkms/

qla4xxx-5.00.04-1dkms/qla4xxx-5.00.04-1dkms.noarch.rpm

qla4xxx-5.00.04-1dkms/README.dkms

qla4xxx-5.00.04-1dkms/dkms-2.0.7-1.noarch.rpm

4. Install the DKMS RPM:

cd qliscsi-linux-5.00.04-1dkms

rpm -ivh dkms-2.0.7-1.noarch.rpm

Output example:

Preparing... ########################################### [100%]

1:dkms ########################################### [100%]

5. Install the QLogic driver RPM:

rpm -ivh qla4xxx-v5.00.04-1dkms.noarch.rpm

An example of the modified /etc/modprobe.conf file is as

follows:

[root@l82bi114 root] # more /etc/modprobe.conf

alias eth0 e1000

alias eth1 e100

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 215 216

Pas de commentaire

EMC QLogic Guide d'installation Page 110