EMC QLogic Guide d'installation télécharger pdf (Page 131)

Updating the QLogic firmware for iSCSI adapters

131

Updating the CEE/Menlo or iSCSI Firmware

Updating the QLogic firmware for iSCSI adapters

The adapter firmware for the QLogic iSCSI HBA is not part of the

Linux driver and is installed in NVRAM on the HBA.

To update the firmware on the iSCSI HBA, follow these steps:

1. Ensure that QLogic SANsurfer and SANsurfer CLI is installed.

Note: Refer to “Upgrading the adapter BIOS” on page 33 for installation

instructions.

2. Copy the appropriate iSCSI firmware file from the CD-ROM or

the EMC-approved section of the QLogic website to the

appropriate directory:

/opt/QLogic_Corporation/SANsurferCLI

3. Execute the following command:

/opt/QLogic_Corporation/SANsurferCLI/scli.

4. Select options 10 (Utilities), then 6 (iSCSI Utility), and then 1

(Update Firmware).

5. The utility prompts to enter a file name. Enter the name of the

iSCSI firmware file obtained in Step 2. The utility should report

the update has completed successfully.

6. Press Enter to return to the main menu, then select options 0

(Return to Main Menu), then 15 to exit the SANsurfer CLI utility.

The new iSCSI firmware update is now in effect.

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 215 216

Pas de commentaire

EMC QLogic Guide d'installation Page 131