EMC Qlogic QLA23xx Guide d'installation télécharger pdf (Page 81)

Installing and configuring the QLogic QLA4010 iSCSI HBA (TOE)

Miscellaneous Planning and Procedures

◆ From the HBA Options, you can set the iSCSI HBA parameters

including IP address, subnet mask, and gateway. If an iSNS

server is being used for your iSCSI configuration follow the

procedure for setting up iSNS later in “Configuring iSNS settings

for QLA4010”, next.

Figure 55 SANsurfer iSCSI HBA manager, HBA options

Configuring iSNS settings for QLA4010

For iSNS support, the QLA4010 must be running the correct driver.

Refer to the EMC Support Matrix for latest version.

Targets must register with the iSNS server. To register, enable the

iSNS server and enter the IP address using the SANsurfer iSCSI

HBA Manager, HBA Options, Network, Enable iSNS dialog box.

Click Save HBA under the Network tab on the SANsurfer iSCSI

HBA Manager, HBA Options tab.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 127 128

Pas de commentaire

EMC Qlogic QLA23xx Guide d'installation Page 81