EMC Qlogic QLA23xx Guide d'installation télécharger pdf (Page 109)

Special instructions for the EMC CLARiiON CX-200-series

109

Miscellaneous Planning and Procedures

Direct-connect dual-host clustering configurations

For CLARiiON CX200-Series direct-connect dual-host cluster

configurations only with QLA234x HBAs, you must follow all

procedures described in this section.

Check for an updated

HBA driver

For CLARiiON CX200-Series direct-connect dual-host cluster

configurations with only QLA234x HBAs, you may need a separate

driver and firmware download. The EMC Support Matrix notes

whether separate driver and firmware files are required.

For each HBA determined to require updated firmware and drivers,

follow the instructions on “Downloading latest QLogic

drivers/firmware/BIOS files” on page 16. Be sure to reference the

Name and Description fields to select the correct CX200-Series

direct-connect dual-host cluster-compatible files.

Reconfigure the HBA

jumper

For CLARiiON CX200-Series direct-connect dual-host cluster

configurations with only QLA234x HBAs, you must change the

default HBA optic jumper position:

CAUTION

Modifying the jumper setting without using the recommended

firmware/drivers can cause the HBA to lose connectivity.

1. Remove the HBA from the server as instructed by your server

guide.

2. Locate jumper(s) J3 (QLA2340) or J3 and J4 (QLA2342), shown in

Figure 64 on page 110.

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 127 128

Pas de commentaire

EMC Qlogic QLA23xx Guide d'installation Page 109