EMC Qlogic QLA23xx Guide d'installation télécharger pdf (Page 31)

Booting from the external storage array

Installation and Configuration

Figure 12 Select Fibre Channel Device window

If no entries appear at any target IDs, verify the following:

• If multiple HBAs are present, verify the HBA select in the

BIOS Utility is the same that currently provides the I/O path

to the storage (at this point, only one I/O path should be

configured to the boot LUN).

• For CLARiiON arrays, verify that the single I/O path points to

the SP which owns the boot LUN.

• For FC-SW environments, verify fabric zoning parameters, so

a single I/O path exists to the boot LUN. Refer to array

software documentation for details.

• Check physical FC connectivity between the HBA and array

(direct attach environment) or switch (FC-SW environment).

9. Select the array port to be used for boot, and press Enter.

If LUNs are allocated to the HBA (using LUN Masking schemes,

such as Access Logix or Volume Logix), they will be presented at

their LUN number.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 127 128

Pas de commentaire

EMC Qlogic QLA23xx Guide d'installation Page 31