112
EMC Fibre Channel and iSCSI with QLogic Host Bus Adapters in the Windows Environment
Miscellaneous Planning and Procedures
Manually installing the HBA driver – Advanced users
To use EMC storage array disks with a Windows host, you need an
EMC-qualified Fibre Channel HBA driver. The HBA kit includes an
EMC-approved driver, which must be installed and configured prior
to partitioning the storage array disks. You also should check the
QLogic website for the latest EMC-approved version. Refer to
“Downloading latest QLogic drivers/firmware/BIOS files” on
page 16.
These procedures are necessary if not using the SANsurfer HBA
Install Wizard. Refer to “Installing HBA driver and software utilities”
on page 69.
Driver revision
History Driver support is as follows:
◆ Version 8.1.5.20 – QLA22xx, QLA23xx (no CX200 series
direct-connect dual host cluster), Windows 2000
◆ Version 8.1.5.21 – QLA23xx, Windows 2000
◆ Version 8.2.1.20 – QLA23xx, Windows 2000
◆ Version 8.2.2.20 – QLA23xx STORPort, Windows 2003 only
◆ Version 8.2.2.25 – QLA23xx, Windows 2000 and Windows 2003
◆ STORPort 8.2.3.26 and SCSIPort 8.2.3.21 – QL23xx, Windows 2003
(SCSI and STOR) and Windows 2000 (SCSI only)
◆ STORPort Version 8.2.3.27 – QLA23xx, Windows 2003 only
◆ STORPort 9.0.0.17 and SCSIPort 9.0.0.12 – QL23xx, Windows 2003
(SCSI and STOR) and Windows 2000 (SCSI only)
◆ STORPort 9.0.1.18 Stratus computers only and SCSIPort 9.0.0.12 –
QL23xx, Windows 2003 (SCSI and STOR) and Windows 2000
(SCSI only)
◆ STORPort 9.0.1.17 and SCSIPort 9.0.1.12 – QL23xx, Windows 2003
(SCSI and STOR) and Windows 2000 (SCSI only)
◆ STORPort 9.0.1.15 and SCSIPort 9.0.1.10 – Dell 2342M/2362M
embedded adapters, Windows 2003 (SCSI and STOR) and
Windows 2000 (SCSI only)
Commentaires sur ces manuels