EMC Qlogic QLA22xx Guide d'installation télécharger pdf (Page 66)

Symmetrix Fibre Channel with Qlogic HBAs on Linux Hosts

Fabric Configurations

Under

SCSI low-level drivers

select EMC-approved QLogic QLA2x00F Driver as modular (M

or m) or static (* or y), as required. (Refer to the above note.)

Select Exit to return to the Main Menu.

From the Main Menu, select Exit; then select Yes to save your

configuration in response to the question

Do you wish to save

your new kernel configuration?

The configuration will be saved to the file /usr/src/linux/.config.

5. Compile the kernel:

make dep

make clean

make install

make modules

make modules_install

cd /boot

6. Build a ramdisk image:

mkinitrd /boot/initrd-$1.img $1

(where $1 is the kernel version)

For example:

mkinitrd /boot/initrd-2.2.17.img 2.2.17

The mkinitrd command is used to create a new ramdisk image and is

dependent upon the loopback device being available. If the loopback

driver is selected in the kernel as a module, ensure that it is loaded with

#lsmod. If the loopback driver was not loaded, insert it with #insmod

loop.

7. Run lilo to update the loading map and reboot:

lilo -v

reboot

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 75 76

Pas de commentaire

EMC Qlogic QLA22xx Guide d'installation Page 66