EMC Qlogic QLA22xx Guide d'installation télécharger pdf (Page 31)

Upgrading to Windows 2003 from Windows 2000 or Windows NT 4.0

2-19

Installing and Configuring the HBA Driver

Upgrading to Windows 2003 from Windows 2000 or

Windows NT 4.0

Note the following if upgrading to Windows 2003:

◆ Upgrading from Windows NT 4.0 — The Windows NT4 drivers

will not be preserved while upgrading to Windows 2003. You

should obtain the correct Windows 2003 drivers (refer to

Downloading QLogic Drivers and Firmware on page 2-2) and

reinstall the drivers after the upgrade is complete.

◆ Upgrading from Windows 2000 — The Windows 2000 drivers

may be preserved while upgrading to Windows 2003. These

SCSIPort drivers (including the native Windows 2003 SCSIPort

drivers) are not supported by EMC for Windows 2003. You

should obtain the correct Windows 2003 drivers (refer to

Downloading QLogic Drivers and Firmware on page 2-2) and

reinstall the drivers after the upgrade is complete.

You may wish to disconnect your storage during the Windows upgrade, and

reconnect it after the approved Windows 2003 drivers have been installed.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 77 78

Pas de commentaire

EMC Qlogic QLA22xx Guide d'installation Page 31