EMC QLogic Guide d'installation télécharger pdf (Page 66)

Configuring a Boot Device on an EMC Storage Array

◆ Disable the BIOS on any other HBAs in the system other than the

QLogic HBA designated for booting.

Configuring the QLogic BIOS for SAN boot

After the BIOS is installed and enabled, it must be configured for use

for booting from the SAN. The following procedure describes how to

configure the BIOS.

1. Connect the Symmetrix fibre channel port to the adapter in the

lowest-numbered PCI slot in the server. For example, if there are

three adapters in the system in slots 2, 4, and 5, connect the cable

to the adapter in slot. Do not connect cables to the other adapters

at this time.

2. Boot the server, and press Ctrl-Q when the QLogic banner is

displayed.

Note: Different HBA models may display different banners. Be sure to

press Ctrl-Q for the HBA to be configured.

The banner display corresponds to the BIOS revision pertinent to

the HBAs currently installed. Refer to the EMC Support Matrix for

specific HBAs and BIOS revisions.

3. After Fast!UTIL loads, the display depends on whether there are

multiple QLogic HBAs installed:

• If there is only one QLogic HBA, the Fast!UTIL Options menu

appears.

• If there are multiple QLogic HBAs, a list of addresses occupied

by those HBAs appears. Since the EMC storage array is

attached to the lowest-numbered PCI slot, select the first

adapter from the list; then press ENTER. The Fast!UTIL

Options menu appears.

4. From the Fast!UTIL Options menu, select Configuration

Settings and press Enter.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 75 76

Pas de commentaire

EMC QLogic Guide d'installation Page 66