EMC QLogic Guide d'installation Page 62

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 76
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 61
62
Configuring a Boot Device on an EMC Storage Array
Common limitations
Boot configurations must not deviate from the following limitations
established by EMC:
The EMC Storage device must have enough disk space to hold the
Linux operating system.
A maximum of 32 volumes may be configured on the EMC
Storage Array port that will be used to boot Linux.
EMC recommends that you install, rather than upgrade, the
kernel-source and kernel UP, SMP, and Hugemem RPMs.
For RHEL4 U4, 4 Gb HBA driver will not load automatically at
boot time. The adapter will not detect boot LUN and give no
device found error.
To force load 4 Gb driver, at the point where it says no device
found, click on ADD DEVICE, then select QLA2400.
VERITAS VxVM/DMP is not supported on Linux hosts booting
from EMC Storage Arrays.
Hosts booting from an EMC Storage Array are limited to the use
of one HBA.
EMC recommends, although it is not required, that the
Symmetrix or CLARiiON device that is to contain the Master Boot
Record (MBR) for the host have a lower logical unit number
(LUN) than any other device visible to the host.
Note that this includes the following cases:
Volume Logix database device when using Volume Logix in a
Symmetrix environment — The installer will fail to write the
MBR to this device, as it is write-protected.
To force the installer to avoid an attempt to write to this
device, EMC recommends masking the LUN. The
administrative host must first initialize the Volume Logix
database. The LUN may then be masked by modifying the
active configuration file to enable the 'fba flag2' to restrict
access to the Volume Logix database.
An alternative to masking the VCM DB is to map the
Volume Logix database device so that it is the highest LUN
presented to the host. Please be aware that the LUN
number should not be higher than 254 (FE).
Vue de la page 61
1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 75 76

Commentaires sur ces manuels

Pas de commentaire